How to Store Colloidal Silver Correctly for Maximum Potency
Whether you use a commercial brand of colloidal silver, or make your own colloidal silver, how long it remains potent during storage depends a lot upon how you store it.
Incorrect storage of colloidal silver can result in the silver particles falling out of suspension and coating the bottom of your storage container like a fine gray silt.
Here’s some quick tips on proper storage of your colloidal silver, so you can enjoy maximum potency no matter how long it’s stored…
Hi, Steve Barwick here, for The Silver Edge…
In a previous article, I explained how to check your
colloidal silver batches to make sure the silver is still potent. You can read that short article, here.
There are three basic factors you need to be aware of:
Factor #1: Bright Light
First and foremost, colloidal silver needs to be stored out of bright light.
That’s because prolonged exposure to bright light causes silver particles to oxidize, then lose their electrical charge and fall out of suspension, dropping to the bottom of your storage container.
As the silver particles begin to fall out of suspension, they’ll coat the bottom of your storage container with a fine gray silt-like coating.
If you see that gray, silt-like coating covering the entire bottom of your colloidal silver storage container, you know that particular batch of colloidal silver is fast losing potency.
That’s because, as more and more silver particles begin to oxidize
and drop to the bottom of the container, fewer and fewer electrically-charged silver
particles will be left suspended in the water.
So when you use the batch, not nearly as many silver particles will be available
to kill bacteria, stimulate healing and boost immunity.
Here’s the good
news: If your colloidal silver is stored
in a dark glass container, it can safely be stored on a kitchen counter top instead
of in a dark cabinet, because the dark color on the glass bottle filters out
the spectrum of light that causes silver particles to oxidize.
A lot of people also use old dark-colored wine bottles, Bailey’s Irish Cream bottles, or other dark glass bottles to store their colloidal silver.
Some people even use inexpensive glass bottles like these, which can be found at Walmart.
You can even wrap duct tape around a clear glass storage container to keep the light out, and store your colloidal silver in that.
If all you have available is a clear glass storage container, one of the simplest solutions is to take a dark sock and pull it up over the container to keep the light out (see a quick “how to” example, here).
The bottom line is that prolonged or frequent exposure to
bright light can begin to oxidize your silver particles and cause them to fall
out of suspension. So to extend the
potency of your colloidal silver in storage you should always do your best to
keep it protected from exposure to bright light.
Factor #2: Temperature Control
Colloidal silver should be stored at room temperature (i.e.,
between 68-85 degrees), rather than, say, in a garage where temperatures can
fluctuate dramatically between daytime and nighttime.
As an aside, never
store colloidal silver in the refrigerator.
That’s because the silver particles are in a state of Brownian Motion, which simply means they repel each other in the
water. This Brownian Motion
helps keep your silver particles from clumping together (i.e., agglomeration)
and becoming too heavy to remain in suspension.
That’s because the positive electrical charge on each silver particle causes the particles to repel from each other, just as trying to touch the positive ends of two magnets causes them to repel from each other. So the silver particles in your batch of colloidal silver are constantly moving, quite literally every second.
Visually, think of an elaborate ballet with a dozen ballet dancers
on stage all weaving in and out between each other in synergism, and you’ll
pretty much get the picture.
The bottom line is to keep your colloidal silver batches stored at room temperature, and let the “dance” (i.e., Brownian motion of the suspended silver particles) continue.
Factor #3: Electro-Magnetic Influences
If possible, your colloidal silver should also be stored three or four feet (or more) away from strong electro-magnetic influences such as a microwave oven, or even from a set of large stereo speakers with large magnets in them.
That's because prolonged exposure to strong electro-magnetic influences can, over time, disrupt the potency of a batch of colloidal silver.
This is probably the least worrisome of storage problems. But it’s another factor that colloidal silver users have found in the past to influence the longevity and potency of their colloidal silver batches.
Another Important Factor
Of course, there are a number of other factors that can influence how long a batch of colloidal silver will remain potent while in storage.
One of the most important factors is the quality of the water that was used to make the colloidal silver batch.
Only steam distilled water should be used when making colloidal silver, because all other forms of water have loads of mineral content in them. And over time, the mineral content can rob your silver particles of their electrical charge, causing them to fall out of suspension.
Even water produced by reverse osmosis still has too much mineral content in it for making high-quality colloidal silver.
This is important to understand, because if you fail to make
your colloidal silver with steam-distilled water, over time the excess mineral
content in the water will begin to bond with the electrically charged silver
particles and rob them of their electrical charge, causing them to fall out of
The Bottom Line
The bottom line is that colloidal silver will retain full
potency quite literally for years if
it’s made properly, and stored properly.
If not, it will only retain potency for a few months at best before
beginning to fall out of suspension and coat the bottom of the storage bottle.
You can do the same thing, with a brand new Micro-Particle Colloidal Silver Generator from The Silver Edge.
Making high-quality colloidal silver that will retain potency for years and years in storage is so simple I’m still stunned more people don’t do so.
In fact, why anyone would continue to pay $20 to $30 for a tiny 4-ounce bottle of colloidal silver in health food stores (which has probably lost half its potency before you bought it) when you can easily make a full quart of long-lasting, full-potency colloidal silver for about 36 cents, is beyond me.
It’s just plain silly to keep paying those exorbitant
mark-ups for health food store colloidal silver when you can make it at actual cost, yourself – just a few cents
per one-quart batch!
4 Simple Steps to
Colloidal Silver-Making Perfection!
The Micro-Particle Colloidal Silver Generator is so simple
to use, anyone can make high-quality micro-particle colloidal
silver for less than 36 cents per quart!
Just plug the two pure .999 fine silver rods into the two jacks in the bottom of the generator box, one on each side of the bubbler tube.
Sit the generator box on top of a one-quart glass jar full of pure steam-distilled water, so that the two silver rods and the bubbler tube are immersed in the water.
Set the handy appliance timer for three hours, and plug it into any convenient grounded household electrical outlet.
Plug the generator into the timer and then turn the timer wheel clockwise until you hear the generator start bubbling. The generator will shut off automatically after three hours.
It’s really that easy! You just “Set it,
and forget it.” And you get a perfect batch of high-quality micro-particle
colloidal silver every time!
The machine simply runs on its own for three hours. And when you’re finished, you’ll have a full quart of high-quality micro-particle colloidal silver. And you can make quart after quart for the rest of your life, for less than 36 cents each!
What’s more, the quality of your homemade colloidal silver is so high it will remain potent for years in storage, if you follow the simple guidelines above.
Why should you ever again pay $20 to $30 for a tiny, four-ounce bottle of colloidal silver at the health food store, when you can make your own superior-quality micro-particle colloidal silver for less than 36 cents per quart?
Where to Learn More…
If you’re interested in learning more, here’s where I suggest you start:
• Read What Real-Life Customers Are Saying -- To read dozens upon dozens of customer reviews and testimonials about the new Micro-Particle Colloidal Silver Generator from the Silver Edge, just click the link in this sentence.
• Discover How It Compares to Other Generators – To learn how the Micro-Particle Colloidal Silver Generator compares to conventional colloidal silver generators, and why it’s been the #1 best-selling colloidal silver generator in the world for over seven years running, just click here.
• Save $100 By Acting Now -- Finally, if you’re ready to order, and you’d like to save a whopping $100 off the cost of a brand new Micro-Particle Colloidal Silver Generator from The Silver Edge during the course of our special sale (next 15 days only), just click this link.
And if you have any questions at all, feel free to call one of the knowledgeable Customer Service Representatives at The Silver Edge, toll-free:
1-888-528-0559 (M-F, 8am to 4pm Pacific Standard Time).
They’ll be happy to answer all of your questions, and take your order for your new Micro-Particle Colloidal Silver Generator when you’re ready. No pushy sales pitch. No pressure.
But keep in mind the special $100 savings mentioned above is available for the next 15 days only.
So if you’ve ever wanted to start making your own high-quality colloidal silver for about a penny per ounce, this is certainly the time to do it while you can still save a whopping $100 off the usual cost of the world’s #1 best-selling colloidal silver generator!
I promise, you’ll never regret purchasing a high-quality Micro-Particle Colloidal Silver Generator from The Silver Edge!
Meanwhile, I’ll be back next week with another great article on colloidal silver….
Yours for the safe, sane and responsible use of colloidal silver,
Steve Barwick, author
Important Note and Disclaimer: The contents of this Ezine have not been evaluated by the Food and Drug Administration. Information conveyed herein is from sources deemed to be accurate and reliable, but no guarantee can be made in regards to the accuracy and reliability thereof. The author, Steve Barwick, is a natural health journalist with over 30 years of experience writing professionally about natural health topics. He is not a doctor. Therefore, nothing stated in this Ezine should be construed as prescriptive in nature, nor is any part of this Ezine meant to be considered a substitute for professional medical advice. Nothing reported herein is intended to diagnose, treat, cure or prevent any disease. The author is simply reporting in journalistic fashion what he has learned during the past 17 years of journalistic research into colloidal silver and its usage. Therefore, the information and data presented should be considered for informational purposes only, and approached with caution. Readers should verify for themselves, and to their own satisfaction, from other knowledgeable sources such as their doctor, the accuracy and reliability of all reports, ideas, conclusions, comments and opinions stated herein. All important health care decisions should be made under the guidance and direction of a legitimate, knowledgeable and experienced health care professional. Readers are solely responsible for their choices. The author and publisher disclaim responsibility and/or liability for any loss or hardship that may be incurred as a result of the use or application of any information included in this Ezine.
Copyright 2016 | Life & Health Research Group, LLC | PO Box 1239 | Peoria AZ 85380-1239 | All rights reserved.